I think Topaz should...

[Ashley Robinson]

Hi George,

3.4 is the current version for Windows. 3.2.5 is the current version for Adjust. However you should still get a fresh download and reinstall.

Sorry for the confusion!

Ashley,

I went to your link and it describes Adjust as V3.4 yet the downloaded version was only V3.2.5 (the same as is already on my machine). By the way, I have a Mac.

Socrates (George)

[Ashley Robinson]

Hi Socrates,

3.2.5 is the current version of Adjust for Mac.

3.4 is the current version of Adjust for Windows

Ashley,

I went to your link and it describes Adjust as V3.4 yet the downloaded version was only V3.2.5 (the same as is already on my machine). By the way, I have a Mac.

Socrates (George)

[iTiki]

Hi Socrates,

3.2.5 is the current version of Adjust for Mac.

3.4 is the current version of Adjust for Windows

Thanks, that clears things up. I have a Mac, too.

[Socrates]

Make "Enable Pupup Help" the default.

[MikeR]

I've found two points with Adjust that I was hoping could be addressed:
1. Can the 'halo effect" at the fringes of images processed with Adjust, Exposure Comp. be eliminated? These "halos" appear to occur when there are similar tones with different colors side by side and Exposure Compensation is pushed to 35 or higher.
2. I do a lot of car photos. Sometimes when you push up Exposure Comp. and Details in Adjust the paving near the car gets more detail and texture, but the paving below the car smooths out. Is there any cure for this processing behavior?

[Mike Savage]

I would like to see the "Fit" button in the preview window actually fit the image to the available window size instead of 50%, 100% or whatever "preset size" actually fits.

Mike

[lwireny]

Dumb Question where do I find the version I have, Mac with Aperture.



Lou

[Sylvia]

I would like to be able to organize the presets with my favorites on top.
Sylvia

[Socrates]

Dumb Question where do I find the version I have, Mac with Aperture.



Lou

Lower right corner...
Menu/About

[Fernando]

The installation process for all of the Topaz products I own correctly identify whether I have an older version installed. However, instead of asking if the installation process can remove the older program, the install requires that the installation process be terminated, control panel opened and the older product removed, THEN restarting of the installation process.

It should all be done from the same installation dialogue as many other Windows programs already do by default. I'm not sure how this process words on a Mac.

Fernando